Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1397

tunnel mpls diff-serv phb-id
tunnel mpls diff-serv phb-id { private privateId | standard standardId } [ exp-bits
Syntax
expBits ]
no tunnel mpls diff-serv phb-id { private privateId | standard standardId }
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the PHB supported by a signaled tunnel.
Description
For E-LSPs, this command also maps the PHB to the specified EXP bits bitValue. You
can repeat the command for up to eight PHB mappings.
For L-LSPs, the exp-bits keyword is not used. If you repeat the command, the most
recent command overwrites the previous command.
The no version removes the mapping association.
Options
Interface Configuration, Tunnel Profile Configuration
Mode
privateId Number, in the range 0–4095, designating the private PHB identifier
standardId Number, in the range 0–63, designating the standard identifier using
the DSCP bits
expBits Number, in the range 0–7, designating the EXP bits
Chapter 8: T Commands
tunnel mpls diff-serv phb-id
1355