Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1385

Chapter 8: T Commands
tunnel group
tunnel group tunnelGroupName
Syntax
no tunnel group
Command introduced before JUNOSe Release 7.1.0.
Release Information
Assigns the specified tunnel group to the domain map. The no version deletes the
Description
tunnel group.
NOTE: By default, no tunnel group is assigned to the domain map. You can assign
a tunnel group to the domain map only if tunnels are not currently defined for the
domain map in Domain Map Tunnel mode.
tunnelGroupName String of up to 64 characters (no spaces)
Options
Domain Map Configuration
Mode
1343
tunnel group