JUNOSe 11.1.x Command Reference Guide N to Z
type
To configure the RTR operation:
Syntax
[ no ] type rtrType protocol ipIcmpEcho destination
[ source-ipaddr srcAddr | source interfaceType interfaceSpecifier ]
To specify the L2TP tunnel type:
type tunnelType
no type
Command introduced before JUNOSe Release 7.1.0.
Release Information
From RTR Configuration mode, configures an RTR operation. The no version removes
Description
the configured type from the operation and resets all configuration for an RTR index.
NOTE: You must configure the operation's type before you can configure any other
characteristics of the operation.
From Domain Map Configuration and Tunnel Group Tunnel Configuration modes,
specifies the L2TP tunnel type (RADIUS attribute 64, Tunnel-Type).
Options
Domain Map Configuration, RTR Configuration, Tunnel Group Tunnel Configuration
Mode
1376
type
rtrType One of the following types of operation:
echo Performs end-to-end operation only
pathEcho Discovers a path to the destination and echoes each device on
the path
destination IP address or an IP hostname or domain name
srcAddr Source IP address
interfaceType Interface type; see Interface Types and Specifiers on page 5
interfaceSpecifier Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
tunnelType L2TP tunnel type