Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1403

Chapter 8: T Commands
tunnel mpls retries
tunnel mpls retries retryNum
Syntax
no tunnel mpls retries
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies for a particular tunnel the number of attempts that will be made to set up
Description
an LSP for RSVP-TE after a failure other than one due to no available route. The no
version restores the default value, 0, which means the attempts will be made until
successful.
retryNum Number of retry attempts in the range 0–65535
Options
Interface Configuration, Tunnel Profile Configuration
Mode
1361
tunnel mpls retries