Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1402

JUNOSe 11.1.x Command Reference Guide N to Z
tunnel mpls priority
tunnel mpls [ traffic-eng ] priority setupPriority [ holdPriority ]
Syntax
no tunnel mpls [ traffic-eng ] priority
Command introduced before JUNOSe Release 7.1.0.
Release Information
Assigns a setup priority and optionally a hold priority to the tunnel. The priority can
Description
range from 0 (the highest) to 7 (the lowest). The hold priority, if set, must be equal
to or better (lower numerically) than the setup priority. In the event of insufficient
resources when a tunnel is being established, its setup priority is evaluated against
the hold priorities of existing tunnels. Tunnels with lower hold priorities (higher
values) are preempted and torn down to free their resources for the new tunnel. The
no version restores the default value.
Options
Interface Configuration, Tunnel Profile Configuration
Mode
1360
tunnel mpls priority
traffic-eng Specifies optional keyword for compatibility with non–E Series
implementations
setupPriority Priority for the tunnel as it is being established; default value is 4
holdPriority Priority for the tunnel after it has been established; default value
is equal to the value of the setup priority