Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1394

JUNOSe 11.1.x Command Reference Guide N to Z
tunnel mpls autoroute metric
tunnel mpls [ traffic-eng ] autoroute metric { absolute | relative } metricValue
Syntax
no tunnel mpls [ traffic-eng ] autoroute metric
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the tunnel metric. The value determines tunnel preference when there is
Description
more than one tunnel or native IP path to a tunnel endpoint. A lower value is preferred
to a higher value. When you set up multiple tunnels, if the primary tunnel goes down,
the existing tunnel with the lowest metric is used immediately. If you specify an
absolute value from 1–2147483647, this value overrides the metric for the path
provided by the IGP. If you specify a relative value from –10 to +10, this value is
subtracted from (–) or added to (+) the metric for the path provided by the IGP. The
no version restores the default value, relative 0, meaning that the tunnel metric is
the IGP value.
Options
Interface Configuration, Tunnel Profile Configuration
Mode
1352
tunnel mpls autoroute metric
traffic-eng Specifies optional keyword for compatibility with non–E Series
implementations
absolute Specifies that the metric is an absolute value
relative Specifies that the metric is a signed relative value
metricValue Preference value for a path; absolute values are in the range
1–2147483647; relative values are in the range –10–+10