Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1400

JUNOSe 11.1.x Command Reference Guide N to Z
tunnel mpls no-route retry-time
tunnel mpls no-route retry-time retryTime
Syntax
no tunnel mpls no-route retry-time
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies for a particular tunnel the interval in seconds between attempts to set up
Description
an LSP for RSVP-TE after a failure due to no available route. The no version restores
the default value, 5 seconds.
Options
Interface Configuration, Tunnel Profile Configuration
Mode
1358
tunnel mpls no-route retry-time
retryTime Number of seconds in the range 1–60