Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1310

JUNOSe 11.1.x Command Reference Guide N to Z
table-map
table-map mapTag
Syntax
For removing route maps for IS-IS IPv6 only:
no table-map
For removing route maps for all other cases:
no table-map [ mapTag ]
Command introduced before JUNOSe Release 7.1.0.
Release Information
Applies the specified route map to all BGP, IS-IS, OSPF, or RIP routes about to be
Description
added to the IP routing table. The no version halts application of the route map.
Options
Address Family Configuration (BGP, IS-IS, RIP), Router Configuration (BGP, IS-IS,
Mode
OSPF, RIP)
1268
table-map
mapTag A string of up to 32 alphanumeric characters that specifies the name
of the route map; for each protocol, the route map can set only the following
values:
BGP Distance, IP next hop, level, metric, metric type, route type, and tag
values
IS-IS Distance, level, metric, metric type, origin, preference, route type,
and tag values; IS-IS IPv6 supports only a single route map
OSPF Distance, metric, metric type, route type, and tag values
RIP Distance, metric, and tag values