Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1447

vlan auto-configure
vlan auto-configure upperInterfaceType [ lockout-time { minTime maxTime |
Syntax
none } ]
no vlan auto-configure upperInterfaceType [ lockout-time ]
Command introduced in JUNOSe Release 7.1.0.
Release Information
lockout-time keyword added in JUNOSe Release 7.3.0.
Specifies the types of dynamic upper interface encapsulations that are accepted or
Description
detected by a dynamic VLAN subinterface. You can issue this command repeatedly
in Profile Configuration mode to include autodetection of multiple upper interface
encapsulation types within the base profile for a dynamic VLAN subinterface. The
no version terminates detection of the specified encapsulation type.
Options
Profile Configuration
Mode
upperInterfaceType One of the following dynamic encapsulation types:
ip
pppoe
minTime Minimum lockout time in the range 1–86400 seconds (24 hours);
default value is 1 second
maxTime Maximum lockout time in the range 1–86400 seconds (24 hours);
default value is 1 second
none Disables lockout time for the specified dynamic encapsulation type
Chapter 9: U, V, W, and Y Commands
vlan auto-configure
1405