Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1389

tunnel local-identity
tunnel local-identity { address ipAddress | subnet ipAddress subnetMask |
Syntax
range ipAddressLow ipAddressHigh }
no tunnel local-identity
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the local identity of the IPSec tunnel. The no version removes the local
Description
endpoint and sets the default identity, which is subnet 0.0.0.0 0.0.0.0.
Options
Interface Configuration
Mode
ipAddress IP address of the local identity
subnetMask Mask applied to the subnet IP address of the local identity
ipAddressLow Lower bound of the range of IP addresses of the local identity
ipAddressHigh Upper bound of the range of IP addresses of the local identity
Chapter 8: T Commands
1347
tunnel local-identity