Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1401

tunnel mpls path-option
tunnel mpls [ traffic-eng ] path-option number
Syntax
{ dynamic | explicit { name pathName | identifier idNumber } }
[ hop-by-hop | ospf | isis ] [ lockdown ]
no tunnel mpls [ traffic-eng ] path-option number
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the path options for a tunnel. You can configure one or more path
Description
options each identified by a unique number for a given tunnel. The path option
number expresses the preference for that option; lower numbers have a higher
preference, with 1 having the highest preference. The no version deletes the path
options.
Options
Interface Configuration, Tunnel Profile Configuration
Mode
traffic-eng Specifies optional keyword for compatibility with non–E Series
implementations
number Identifier for a set of path options
dynamic Specifies that the path is dynamically calculated
explicit Specifies that an explicit path is used
pathName Name of the explicit path; string of up to 20 characters
idNumber Number identifying the explicit path; in the range 1–65535
hop-by-hop Specifies that hop-by-hop routing is used for this path option
ospf Specifies that OSPF routing is used for this path option
isis Specifies that IS-IS routing is used for this path option
lockdown Specifies that optimization is not done for this path option
Chapter 8: T Commands
tunnel mpls path-option
1359