Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1451

vlan bulk-config modify
To modify VLAN ranges containing single-tagged VLAN IDs:
Syntax
vlan bulk-config bulkConfigName modify vlan-range vlanIdStart vlanIdEnd
To modify VLAN ranges containing double-tagged S-VLAN IDs or based on
agent-circuit-identifier:
vlan bulk-config bulkConfigName modify svlan-range s-vlanIdStart s-vlanIdEnd
{ vlanIdStart vlanIdEnd | any | agent-circuit-identifier }
Command introduced in JUNOSe Release 7.3.0.
Release Information
Modifies the VLAN subrange values for the specified bulk configuration VLAN range.
Description
If the new subrange encompasses previously configured subranges within that range,
those subranges are merged into the new one, freeing subrange resources. There is
no no version.
Options
Interface Configuration
Mode
bulkConfigName Name of the VLAN range; string of up to 80 characters
vlanIdStart Starting VLAN ID of the VLAN subrange you are configuring
vlanIdEnd Ending VLAN ID of the VLAN subrange you are configuring
s-vlanIdStart Starting S-VLAN ID of the S-VLAN subrange you are configuring
s-vlanIdEnd Ending S-VLAN ID of the S-VLAN subrange you are configuring
any Specifies the VLAN ID as a wildcard
agent-circuit-identifier Specifies a VLAN range that is based on
agent-circuit-identifier information
Chapter 9: U, V, W, and Y Commands
vlan bulk-config modify
1409