Juniper JUNOSE 11.1.X - COMMAND REFERENCE N TO Z 4-6-2010 Command Reference Manual page 1399

Chapter 8: T Commands
tunnel mpls no-route retries
tunnel mpls no-route retries retryNum
Syntax
no tunnel mpls no-route retries
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies for a particular tunnel the number of attempts that will be made to set up
Description
an LSP for RSVP-TE after a failure due to no available route. The no version restores
the default value, 0, which means the attempts will be made until successful.
retryNum Number of retry attempts in the range 0–65535
Options
Interface Configuration, Tunnel Profile Configuration
Mode
1357
tunnel mpls no-route retries