Mounting Instructions For Sealings - ABB IRB 7600 Product Manual

4.2.3 Mounting instructions for sealings

General
This section describes how to mount different types of sealings.
Equipment
Consumable
Grease
Rotating sealings
The following procedures describe how to fit rotating sealings.
Radial sealings
A radial sealing consists of a flexible rubber lip bonded to a rigid metal case. Only
one side of the sealing is static with a metal insert.
xx2300000433
Product manual - IRB 7600
3HAC022033-001 Revision: AH
CAUTION
Please observe the following before commencing any assembly of sealings:
• Protect the sealing during transport and mounting, especially the main lip
on radial sealings.
• Keep the sealing in its original wrappings or protect it well before actual
mounting.
• The fitting of sealings and gears must be carried out on clean workbenches.
• Use a protective sleeve for the main lip during mounting, when sliding over
threads, keyways or other sharp edges.
• Do not lubricate a static side of a sealing with grease, since this may result
in movement of the sealing during operation.
The only exception for lubrication of static sides of a sealing, is to use P-80
rubber lubrication gel against certain aluminium surfaces. If usage of P-80
is relevant, it is stated in the repair procedures.
© Copyright 2007 - 2023 ABB. All rights reserved.
4.2.3 Mounting instructions for sealings
Article number Note
3HAC042536-001 Shell Gadus S2
4 Repair
Continues on next page
209