ABB IRB 7600 Product Manual page 344
Hide thumbs
Also See for IRB 7600:
- Product manual, spare parts (56 pages) ,
- Product manual (456 pages) ,
- Instructions manual (82 pages)
Table of Contents
Advertisement
4 Repair
4.7.2 Replacement of gearbox, axis 2
Continued
4
5
6
7
8
9
10
Continues on next page
344
Action
DANGER
Turn off all:
•
electric power supply to the robot
•
hydraulic pressure supply to the robot
•
air pressure supply to the robot
Before entering the robot working area.
If the robot is fitted with moveable mechanical
stops on axis 2 (not stock equipment), these must
be removed at this point.
The attachment holes of the mechanical stops
are used to attach the fixture, lower arm.
Secure the lower arm to the frame by inserting
the locking screw into the hole.
Fit the fixture, lower arm to prevent the lower arm
from falling.
•
Make sure that both adjusters (B) on the
fixture are screwed back.
•
Align the fixture with the frame and lower
arm.
•
Tighten the four M16 bolts (C) on the in-
side of the frame, in attachment holes, with
tightening torque: 220 Nm.
•
Screw in the two adjusters (B) until they
rest against the flats on the lower arm.
Tighten by hand.
•
Lock, using the two ring nuts (D).
•
Tighten the two M12 bolts (E) in the attach-
ment holes, fixture lower arm with tighten-
ing torque: 91 Nm.
Unload the balancing device shaft by using a
specific press tool.
DANGER
Handling the tool incorrectly will cause serious
injury.
Read and follow enclosed user instructions for
the tool.
Drain the gearbox, axis 2.
Remove the motor, axis 2.
© Copyright 2007 - 2023 ABB. All rights reserved.
Note
Art. no. is specified in
Required
equipment on page
342!
Shown in the figure
Location of
gearbox on page
341!
Art. no. is specified in
Required
equipment on page
342!
Attachment holes for the fixture are
shown in the figure
Location of
gearbox on page
341!
Make sure the fixture is pressed
tightly against the lower arm before
securing with screws!
xx0200000261
•
A: Locking screw, lower arm
Detailed in section
Unloading the
balancing device on page
Detailed in section
Draining, oil on
page
169.
Detailed in section
Removal, motor
on page
299.
Product manual - IRB 7600
3HAC022033-001 Revision: AH
284.
Advertisement
Table of Contents
