ABB IRB 7600 Product Manual page 68

2 Installation and commissioning
2.5.2 Lifting robot with lifting accessory (recommended lifting method)
Continued
Slings attached directly onto robot
This section details how to lift and move the robot using lifting slings when these
are attached directly onto the robot.
1
2
3
4
5
6
68
Note
Please refer to the enclosed user instruction for instruction how to place the
manipulator in an correct position. Attempting to lift a manipulator in any other
position may result in the robot tipping over, causing severe damage or injury!
Action
Run the overhead crane to a position above
the robot.
Position the robot as detailed in enclosed in-
struction!
Fit the lifting accessory to the robot as de-
scribed in the enclosed instruction!
Go to the user instructions enclosed with the
lifting accessory.
DANGER
Handling the tool incorrectly will cause serious
injury.
Read and follow enclosed user instructions
for the tool.
CAUTION
The IRB 7600 robot weighs 2500 kg.
All lifting accessories used must be sized ac-
cordingly!
WARNING
Personnel must not, under any circumstances,
be present under the suspended load!
Raise overhead crane to lift the robot.
© Copyright 2007 - 2023 ABB. All rights reserved.
Note
Article number is specified in
equipment on page 67.
Release the brakes, if required, as de-
tailed in section Manually releasing the
brakes on page 71.
Article number is specified in
equipment on page 67.
Make sure all hooks and attachments
maintain their correct positions while
lifting the robot!
Always move the robot at very low
speeds, making sure it does not tip.
Product manual - IRB 7600
3HAC022033-001 Revision: AH
Required
Required