ABB IRB 7600 Product Manual page 353

4
5
6
7
8
9
10
11
Product manual - IRB 7600
3HAC022033-001 Revision: AH
Action
Remove the motor, axis 3.
Remove the upper arm.
Remove the sealing, axis 2/3
between the gearbox and lower
arm.
Place the upper arm safely on a
workbench, in a fixture or similar.
Remove the attachment screws,
gearbox.
Fit the two guide pins in 180° rela-
tion to each other in the gearbox
attachment screw holes.
Fit the Lifting accessory RV2 ac-
cording to figure.
If required, use screws in the holes
(A) shown in the figure to the right
to press the gearbox free.
© Copyright 2007 - 2023 ABB. All rights reserved.
4.7.3 Replacement of gearbox, axis 3
Note
Detailed in section Removal, motor on page
Note
When removing the motor axis 3, the brake on axis
3 is released. Make sure the upper arm is secured
and disabled to move!
Detailed in section Removal, upper arm on
page 244.
On reassembly a new sealing must be used! Art.
no. is specified in Required equipment on page
Shown in the figure Location of gearbox on
page 350.
Art. no. is specified in Required equipment on
page 351.
xx0900000113
xx0200000033
• A: M16 holed for pressing the gearbox out
Continues on next page
4 Repair
Continued
305.
351.
353