ABB IRB 7600 Product Manual page 324
Hide thumbs
Also See for IRB 7600:
- Product manual, spare parts (56 pages) ,
- Product manual (456 pages) ,
- Instructions manual (82 pages)
Table of Contents
Advertisement
4 Repair
4.6.6 Replacement of motor, axis 6
Continued
Removal, motor
The procedure below details how to remove the motor, axis 6.
1
2
3
4
5
6
Continues on next page
324
Action
If the robot is to be calibrated with refer-
ence calibration:
Find previous reference values for the axis
or create new reference values. These val-
ues are to be used after the repair proced-
ure is completed, for calibration of the ro-
bot.
If no previous reference values exist, and
no new reference values can be created,
then reference calibration is not possible.
If the robot is to be calibrated with fine
calibration:
Remove all external cable packages
(DressPack) and tools from the robot.
Note
Robots with protection type Foundry Plus or Foundry Prime require special repair
routines to maintain the tightness level, in addition to the procedure below,
described in
Replacement of the motor axis 6 (Foundry Plus) on page
Action
Decide which calibration routine to use, and take
actions accordingly prior to beginning the repair
procedure.
Move the robot to one of the recommended posi-
tions:
•
to a position where the motor in axis 6 is
pointed straight up. This position enables the
motor to be replaced without draining the
gear oil, which in turn saves time.
•
to a position where the motor in axis 6 is
close to horizontal. This position may be se-
lected when the gearbox is to be replaced,
i.e. when the gearbox oil has to be drained
anyway.
DANGER
Turn off all:
•
electric power supply to the robot
•
hydraulic pressure supply to the robot
•
air pressure supply to the robot
Before entering the robot working area.
In horizontal position: drain the oil from the axis 6
gearbox.
Remove the rear motor cover by unscrewing the
five attachment screws.
Disconnect all connectors beneath the cover.
© Copyright 2007 - 2023 ABB. All rights reserved.
Note
Follow the instructions given in the refer-
ence calibration routine on the FlexPendant
to create reference values.
Creating new values requires possibility to
move the robot.
Read more about reference calibration for
Axis Calibration in
Reference calibration
routine on page
390.
Note
Detailed in section
gearbox axis 6 on page
Product manual - IRB 7600
3HAC022033-001 Revision: AH
326.
Draining oil,
182.
Advertisement
Table of Contents
