ABB IRB 7600 Product Manual page 289

Refitting the balancing device shaft
1
2
3
4
5
Product manual - IRB 7600
3HAC022033-001 Revision: AH
Action
Lubricate the shaft with grease.
Fit the shaft to the piston shaft front eye
through the hole in the frame, using the press
equipment, balancing device shaft, according
to user instructions enclosed with the equip-
ment.
xx0900000813
Go to the user instructions enclosed with the
press tool.
DANGER
Handling the tool incorrectly will cause serious
injury.
Read and follow enclosed user instructions for
the tool.
Refit the securing screw and washer into the
shaft using locking liquid.
Lubricate the spherical roller bearing through
the lubrication nipple in the ear with grease,
approximately 5 grams.
Clean the area from any excessive grease.
© Copyright 2007 - 2023 ABB. All rights reserved.
4.5.4 Replacing the balancing device
Note
Art. no. is specified in
equipment on page
Art. no. is specified in
equipment on page
User instructions are enclosed with
the tool.
Note
Make sure the shaft is pressed all
the way to the bottom.
M16 x 180, tightening torque: 120
Nm.
Locking liquid is specified in
quired equipment on page
Art. no. and amount are specified in
Required equipment on page
Lubrication is further detailed in
section Lubrication of spherical roller
bearing, balancing device on
page 189.
Continues on next page
4 Repair
Continued
Required
282!
Required
282!
Re-
282!
282!
289