Parameter Setting Function; Module Parameters - Mitsubishi Electric NZ2GN2S-D41P01 User Manual

8.6

Parameter Setting Function

This section describes how to set the module parameters and FPGA parameters.

Module parameters

Set the module parameters.
By selecting the setting value on the Work window and selecting the initialization menu by right-clicking, the
setting value can be initialized.
Operating procedure
1.
It is done from "Module Parameter".
[Menu]  [Module Parameter]
Item
Host station IP IP address
address setting
Subnet mask
Setting of module FPGA control automatic
start start setting
FPGA control automatic
start delay setting
CC-Link IE TSN FPGA control
FPGA control continuation setting
setting
Logging setting Logging function enable/
disable
Logging data file storage
*2
type
CSV Format setting
Description
Sets the IP address of your own station in
standalone mode.
Sets the subnet mask of the host station in
standalone mode.
Sets whether to automatically start FPGA
control after configuration is complete.
Sets the time from configuration
*1
completion until the automatic start of
FPGA control.
Sets whether to stop or continue FPGA
control when the data link with the CPU
module and master station is broken during
module operation in CC-Link TSN
communication mode.
Enables or disables the logging function.
Sets the format of the saved data when
transferring the collected logging data to
the FTP server.
When the logging data time division setting
is time division mode, this setting is fixed to
binary file.
*3
Page 97 CSV Format setting
Setting range
1.0.0.1 to 223.255.255.254
(The beginning of the IP address must
start with a value between 1 and 223,
excluding 127.)
• Blank
• 128.0.0.0 to 255.255.255.252
• Disable
• Enable
0 to 255
• Stop
• Continue
• Disable
• Enable
• Binary file
• CSV file
8 FPGA MODULE CONFIGURATION TOOL
8.6 Parameter Setting Function
8
Default
192.168.3.250
Blank
Disable
0
Stop
Disable
Binary file
95