Appendix 3 Remote Buffer Memory; List Of Remote Buffer Memory Areas - Mitsubishi Electric NZ2GN2S-D41P01 User Manual

Appendix 3
Describes the remote buffer memory.
The SLMP command and dedicated instructions (REMTO, REMTOD, REMTOIP, REMTODIP, REMFR, REMFRD, REMFRIP,
and REMFRDIP instructions) can be used to read from and write to the remote buffer memory.
For the dedicated instructions, refer to the following.
 MELSEC iQ-R Programming Manual (Module Dedicated Instructions)
For SLMP commands, refer to the following.
Page 351 SLMP Communication Function
• Do not read or write data from/to any "Use prohibited" remote buffer memory areas. Doing so may result in
an accident due to an incorrect output or malfunction.
• For a single FPGA module, do not execute multiple dedicated instructions at the same time. If multiple
dedicated instructions are executed at the same time, the FPGA module may be unable to receive the
dedicated instructions, and the dedicated instructions may time out.

List of remote buffer memory areas

Module parameter area
■Function setting switch setting
: Applicable, : Not applicable
Address
Hexadecimal Decimal
04D0H 1232
■Setting of module start
: Applicable, : Not applicable
Address
Hexadecimal Decimal
04D1H 1233
04D2H 1234
■Parameter setting
: Applicable, : Not applicable
Address
Hexadecimal Decimal
04D3H 1235
■Operation setting during disconnection
: Applicable, : Not applicable
Address
Hexadecimal Decimal
04D4H 1236
APPX
488

Appendix 3 Remote Buffer Memory

Remote Buffer Memory
Name
User switch enable/disable
Name
FPGA control automatic start setting
FPGA control automatic start delay setting
Name
User circuit part parameter size
Name
FPGA control continuation setting
Default Read Write
value
0H  
Default Read Write
value
0H  
0  
Default Read Write
value
 
0
Default Read Write
value
0  