Hold Function Setting; Operating The Lossnay Group; Mode; Fan Speed Setting - Mitsubishi Electric TC-24A Instruction Book

Basic Operations (cont'd)

Hold Function Setting

HOLD-ON
Touch ⑤ to enable/disable the hold function.
* When the hold function is enabled, the current operation status is retained until the hold
function is disabled.
* When this function is enabled, the scheduled operation will be prohibited as well as the following
remote controller operations: Stop, operation mode change, preset temperature change.
is displayed while the hold function is enabled.

Operating the LOSSNAY group

Displays that are not marked by numbers on the screen are the same as those on the Air conditioning unit group screen.
② ①

Operating the General equipment group

Displays that are not marked by numbers on the screen are the same as those on the Air conditioning unit group screen.
24
HOLD-OFF
③ ④

Mode

Touch ① to access the modes in the order "Bypass,
Heat recovery, Auto."
The selected mode will appear in the area marked ②.
* Available mode varies depending on the model.
Modes that are unavailable do not appear.

Fan speed setting

Touch ③ to access the fan speeds in the order
"Low, High."
The selected fan speed will appear in the area
marked ④.
Displays the general equipment type.
*When changing icons, refer to Initial Setting Manual.

ON/OFF operation

• When the general equipment is turned on,
the output contact of DIDO controller (PAC-
YG66DCA) also turns on.
• When the general equipment is turned off,
the output contact of DIDO controller (PAC-
YG66DCA) also turns off.