Ethernet Cables - Mitsubishi Electric NZ2GN2S-D41P01 User Manual

Ethernet cables

Wiring method
■Installation procedure
1.
Power off the FPGA module and the external device.
2.
Push the Ethernet cable connector into the FPGA module until it clicks. Pay attention to the connector's orientation.
3.
Power on the FPGA module.
4.
Power on the external device.
5.
Check that the P1 LINK LED/P2 LINK LED of the port into which the Ethernet cable is connected is on.
*1 The time taken for P1 LINK LED/P2 LINK LED to turn on after connection of the cable may vary. The LINK LED normally turns on in a
few seconds. However, if link-up processing is repeated due to the status of a device on the line, the longer time may be required. If the
P1 LINK LED/P2 LINK LED does not turn on, refer to the following and take a corrective action.
Page 435 When the P1 LINK LED or P2 LINK LED turns off
*2 When connecting the FPGA module with the communication speed of 100Mbps to a device with the speed of 100Mbps, enable the auto-
negotiation for that device.
Both the P1 (upper) and P2 (lower) connectors can be used.
• When using one of them in a star topology, either P1 or P2 can be connected.
• When using both connectors (P1 and P2) in a line topology and a ring topology, P1-P1, P2-P2, and P1-P2
connections are possible.
■Disconnection procedure
1.
Power off the FPGA module.
2.
With the latch of the Ethernet cable pressed, unplug the cable.
7 INSTALLATION AND WIRING
68
7.4 Wiring
*1*2