Mitsubishi Electric NZ2GN2S-D41P01 User Manual page 494

FPGA control automatic start delay setting
■Address
Name
FPGA control automatic start delay setting
■Description
Sets the time from FPGA configuration completion until the automatic start of FPGA control.
■Setting range
0 to 255[s] (Default: 0)
When the value outside of the setting range is specified, the FPGA module works as 255.
■Enabling the setting
When Parameter save request (RY2) is turned on and off, the setting is enabled.
User circuit part parameter size
■Address
Name
User circuit part parameter size
■Description
From the start address of the write data (transient area) in the FPGA register of the user circuit part, sets the size to be saved
in non-volatile memory as the FPGA parameter in units of words.
After FPGA configuration is complete, parameters of a size equivalent to that saved in non-volatile memory are set to Write
data (transient area) in FPGA register.
■Setting range
0 to 384 (Default: 0)
If a value other than the above is set, it works as 384.
■Save to non-volatile memory
When saving FPGA register areas to non-volatile memory, turn on and off FPGA parameter save request (RY2).
APPX
492
Appendix 3 Remote Buffer Memory
Remote buffer memory address
04D2H
Remote buffer memory address
04D3H