Mitsubishi Electric NZ2GN2S-D41P01 User Manual page 59

Initializing IP address in stand-alone mode
In stand-alone mode, the FPGA module can initialize the IP address and the subnet mask stored in the non-volatile memory.
The initialized IP address and subnet mask are as follows.
• IP address: 192.168.3.250
• Subnet mask: 255.255.255.0
Operating procedure
1.
Power off the FPGA module.
2.
Set the IP address/station number setting switches and function setting switches as follows.
• IP address/station number setting switch: 255
• Function setting switch 1: ON
• Function setting switch 2: ON
3.
Power on the FPGA module.
4.
When the initialization starts, the RUN LED flashes.
5.
When the initialization is complete, the RUN LED turns off.
6.
Power off the FPGA module.
7.
Set the IP address/station number setting switches and function setting switches as follows.
• Function setting switch 2: OFF
• IP address/station number setting switch: IP address fourth octet
8.
Power on the FPGA module.
7 INSTALLATION AND WIRING
7.1 Setting Switches
7
57