Troubleshooting Windrower Problems; Displaying The Windrower And Engine Error Codes - MacDon M Series Unloading And Assembly Instructions

4.7 Troubleshooting Windrower Problems

4.7.1 Displaying the Windrower and Engine Error Codes

NOTE:
The header MUST be attached to the windrower to perform this procedure.
1. Turn ignition key to RUN, or start the engine.
2. Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter Programming Mode. Press
SELECT (C).
• WINDROWER SETUP? is displayed on the
upper line.
3. Press SELECT (C) until DIAGNOSTIC MODE? is
displayed in upper line.
• NO/YES is displayed on the lower line.
147962
CAB DISPLAY MODULE (CDM)
Figure 4.230: M105 CDM Programming Buttons
Figure 4.231: M155 CDM Programming Buttons
Figure 4.232: M205 CDM Programming Buttons
253
Revision A