Activating The Header Float Control Lockout - MacDon M Series Unloading And Assembly Instructions

6. Press SELECT (D) until DISK SPEED is displayed on
the upper line.
• ENABLED/LOCKED is displayed on the lower line.
7. Press left arrow (B) to enable DISK SPEED control
switch, or press right arrow (C) to lock DISK SPEED
control switch.
8. Press PROGRAM (A) to exit Programming Mode or
press SELECT (D) to proceed to next WINDROWER
SETUP action.

4.5.3 Activating the Header Float Control Lockout

NOTE:
The header MUST be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
147962
CAB DISPLAY MODULE (CDM)
Figure 4.168: M155 Disc Speed Control Lock
Figure 4.169: M205 Disc Speed Control Lock
227
Revision A