Configure Udp Serial Mode - Digi TX54 User Manual

Serial port
iv. (Optional) Enable mDNS. mDNS is a protocol that resolves host names in small
networks that do not have a DNS server.
8. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure UDP serial mode

The UDP serial mode option in the serial port configuration provides access to the serial port using
UDP.
To change the configuration to match the serial configuration of the device to which you want to
connect:

WebUI
TX54 User Guide
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config serial USB_port)> ... firewall zone ?
Zones: A list of groups of network interfaces that
can be referred to by packet
filtering rules and access control lists.
Additional Configuration
-------------------------------------------------
------------------------------
any
dynamic_routes
edge
external
hotspot
internal
ipsec
loopback
setup
(config serial USB_port)>
Repeat this step to list additional firewall zones.
(config serial USB_port)> service ssh mdns enable true
(config serial USB_port)>
Configure UDP serial mode
194