QFX10008 Switch Hardware Guide
See Also
Unpacking QFX10000 Line Cards, Routing and Control Boards, and Switch Interface Boards
144
Remove the plastic cover from the switch chassis.
7.
Use a 13/32 in. (10 mm) open-end or socket wrench to remove the four sets of bracket
8.
bolts that secure the chassis to the shipping pallet (see
Figure 61: Bracket Bolt Removal
Unpack the accessory box and lay out the contents so that they are ready for use.
9.
Verify that your order includes all appropriate parts. See
10.
Order to the Packing List" on page 146
information about base configurations and redundant configurations.
Store the brackets and bolts inside the accessory box.
11.
Save the shipping box and packing materials in case you need to move or ship the
12.
switch at a later time.
Installing the QFX10008 into a Rack on page 152
Orders for line cards, additional Routing and Control Boards (RCBs), and Switch Interface
Boards (SIBs) components are FRUs that are shipped separately from the switch chassis.
The housing for the RCBs and line cards are rigid sheet-metal structures that house the
electronics. SIBs have an exposed printed circuit board on one side and sheet metal on
Figure 61 on page
"Comparing the QFX10000
and
"QFX10008 Configurations" on page 31
Copyright © 2019, Juniper Networks, Inc.
144).
for