Figure 47: Qfx10000-60S-6Q Port Panel - Juniper QFX10008 Hardware Manual

QFX10008 Switch Hardware Guide
86

Figure 47: QFX10000-60S-6Q Port Panel

1
1— Power LED, status LED, and offline button
2—SFP+ ports
Each QSFP28 port ( and
60
100-Gigabit Ethernet using QSFP28 optical transceivers. The interface speeds are
configured by port group. When a QSFP28 transceiver is inserted into the one of the
QSFP28 ports marked with a fine black line above the port (
configured for 100-Gigabit Ethernet, the two adjacent ports are disabled and the
QSFP28 port is enabled for 100-Gigabit Ethernet. When port
100-Gbps, ports 61 and 62
and are disabled.
63 65
40-Gigabit Ethernet using QSFP+ optical transceivers. The default speed is 40 Gbps.
10-Gigabit Ethernet using breakout cabling and attached optical transceivers. When
configured for channelization, the system converts the 40-Gigabit Ethernet port into
4 independent 10-Gigabit Ethernet ports. Use the
port-number channel-speed speed
Each QSFP+ port (
61, 62, 63,
associated QSFP28 port (
QSFP+ ports can be configured to support:
40-Gigabit Ethernet using QSFP+ optical transceivers. The default speed is 40 Gbps.
10-Gigabit Ethernet using breakout cables with attached optical transceivers. When
configured for channelization, the system converts the 40-Gigabit Ethernet port into
4 independent 10-Gigabit Ethernet ports. Use the
port-number channel-speed speed
Each SFP+ port ( through
0
10-Gigabit Ethernet using SFP+ optical transceivers. The default speed is 10 Gbps.
1-Gigabit Ethernet using SFP optical or SFP-T copper transceivers.
Copper SFP transceivers are only supported on the bottom two SFP+ rows. Because
copper SFP transceivers (1000BASE-T) are physically larger than optical SFP
transceivers (1000BASE-X), stacking copper SFP transceivers in all three rows causes
internal damage to the line card. Optical SFP transceivers can be stacked and used in
all SFP+ ports 0 through
2
4
3— QSFP28 ports, QSFP+ ports, and port
groups
) controls a port group and can be configured to support:
64
are disabled; when port
command to change the port speed.
and is part of a port group and is controlled either by the
65
60 or 64 ). A QSFP28 port operating at 40-Gpbs speeds, the
command to change the port speed.
) can be configured to support:
59
59 .
3 QFX10000-60S-6Q
60 or 64 ) and the port is
is configured for
60
64 is configured for 100-Gbps, ports
set chassis fpc slot-number port
set chassis fpc slot-number port
Copyright © 2019, Juniper Networks, Inc.