Unpacking And Mounting The Ex4200 Switch; Unpacking An Ex4200 Switch - Juniper EX4200 Hardware Manual

Unpacking and Mounting the EX4200 Switch

IN THIS SECTION

Unpacking an EX4200 Switch | 110

Parts Inventory (Packing List) for an EX4200 Switch | 111
Register Products—Mandatory to Validate SLAs | 114
Installing and Connecting an EX4200 Switch | 114
Mounting an EX4200 Switch | 115
Mounting an EX4200 Switch on a Desk or Other Level Surface | 116
Mounting an EX4200 Switch on Two Posts in a Rack or Cabinet | 117
Mounting an EX4200 Switch on Four Posts in a Rack or Cabinet | 120
Mounting an EX4200 Switch in a Recessed Position in a Rack or Cabinet | 123
Mounting an EX4200 Switch on a Wall | 124
Unpacking an EX4200 Switch
The EX4200 switch chassis is a rigid sheet-metal structure that houses the hardware components. EX4200
switches are shipped in a cardboard carton, secured with foam packing material. The carton also contains
an accessory box.
CAUTION:
not unpack the switches until you are ready to begin installation.
To unpack the switch (see
1. Move the shipping carton to a staging area as close to the installation site as possible, but where you
have enough room to remove the system components.
2. Position the carton so that the arrows are pointing up.
3. Open the top flaps on the shipping carton.
EX4200 switches are maximally protected inside the shipping carton. Do
Figure 29 on page 111):
110