Figure 112: Removing A Dc Power Supply From A Qfx10008 - Juniper QFX10008 Hardware Manual

Copyright © 2019, Juniper Networks, Inc.
Rotate the captive screw away from the faceplate of the power supply to release the
5.
latch. See Figure 112 on page 199
Taking care not to touch power supply components, pins, leads, or solder connections,
6.
place one hand under the power supply to support it. Grasp the power supply handle
with your other hand and pull the power supply completely out of the chassis.
If you are not replacing the power supply, install the cover over the slot.
7.
Insert your thumb and forefinger into the finger holes of the cover.
a.
Squeeze and place the cover in the slot.
b.
Release your fingers and the cover remains in the slot.
c.
Unscrew the screw on the plastic cable cover that shield the input terminal studs
8.
counterclockwise by using the Phillips (+) screwdriver, number 2.
Unscrew the nuts counterclockwise using the 13/32 in. (10 mm) nut driver or socket
9.
wrench from the input terminal studs.
Remove the cable lugs from the input terminal studs.
10.

Figure 112: Removing a DC Power Supply from a QFX10008

Chapter 4: Maintaining Components
and Figure 113 on page 200.
199