Installing The Mounting Hardware For A Qfx10000 - Juniper QFX10008 Hardware Manual

QFX10008 Switch Hardware Guide
Table 67: QFX10000 Front Panel Kit (continued)
Component
Warranty card
Related
Documentation

Installing the Mounting Hardware for a QFX10000

150
QFX10008 Configurations on page 31
The switch can be installed in a four-post rack or in an open-frame rack. Install the
mounting hardware on the rack before installing the switch.
To mount the chassis on a four-post rack, you must first install the mounting brackets
in the rack. QFX10008 and QFX10016 switches come with a four-piece set of mounting
brackets that supports the chassis in the rack. If you prefer a solid-shelf design for the
rack, JNP-MOD-RMK-4PST is available by separate order.
NOTE: Two-post installation racks are not supported.
The four mounting bracket pieces are:
One left base bracket. The bracket is labeled "LEFT FRONT" on the side of the bracket
that faces the interior of the rack, near the holes for attaching the bracket to the rack.
One right base bracket. The bracket is labeled "RIGHT FRONT" on the side of the bracket
that faces the interior of the rack, near the holes for attaching the bracket to the rack.
Two rear brackets. These brackets are labeled "REAR" on the side of the bracket that
faces the interior of the rack, near the holes for attaching the bracket to the rack. The
rear brackets are interchangeable; you can use either of the rear brackets with the right
or left base bracket.
Ensure that you have the following parts and tools available to install the mounting
brackets:
A Phillips (+) screwdriver, number 1, 2, or 3, depending on the size of your rack-mounting
screws
A Phillips (+) screwdriver, number 2, to install the screws that connect the rear and
base brackets
16 mounting screws appropriate for your rack to attach the four mounting bracket
pieces to the rack
When you install the base and rear brackets, the adjustable portion of the brackets
overlap. Use the overlap area to adjust the total bracket length to fit any of the four
standard rack sizes: 19 in. (483 mm), 23.62 in. (600 mm), 30 in. (762 mm), or 31.5 in.
(800 mm).
Quantity
1
Copyright © 2019, Juniper Networks, Inc.