Qfx10000 Status Panel Leds - Juniper QFX10008 Hardware Manual

QFX10008 Switch Hardware Guide
Table 5: FRUs in an QFX10000 (continued)
FRU
Control Board
Switch Interface Boards (SIBs)
Line cards
Optical transceivers
See the Hardware Compatibility
Tool .

QFX10000 Status Panel LEDs

36
Type
Redundant configuration:
Master Control Board is hot-pluggable.
Backup Control Board is hot-insertable and hot-removable.
Base configuration:
Removal of the Control Board will cause the switch to shut down. You can install a
replacement Control Board in the second slot. The system will restart to elect a master
and backup. If necessary, you can switch the master and backup using the
chassis routing-engine master switch
See "QFX10008 Configurations" on page 31
Configurations.
SIBs are hot-insertable and hot-removable. We recommend that you take SIBs offline
before removing them to avoid traffic loss while the switch fabric is being reconfigured.
For example:
user@switch> request chassis sib (offline | online) slot slot-number offline
Hot-insertable and hot-removable. We recommend that you take line cards offline before
removing them. For example:
user@switch> request chassis fpc slot slot-number offline
Hot-insertable and hot-removable.
NOTE: Line cards are not part of the base or redundant configuration. You
must order them separately.
NOTE: If you have a Juniper Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
to do so can result in significant delays if you need replacement parts. This
note does not apply if you replace an existing component with the same type
of component.
The status panel of the QFX10008 and QFX10016 has two purposes:
Shows the overall status of the chassis
command.
and QFX10016 Components and
Copyright © 2019, Juniper Networks, Inc.
request
. Failure