Connecting The Qfx10000 To External Devices; Connecting A Device To A Network For Out-Of-Band Management; Connecting A Device To A Management Console By Using An; Figure 77: Rj-45 Connector On An Ethernet Cable - Juniper QFX10008 Hardware Manual

QFX10008 Switch Hardware Guide
See Also
Related
Documentation

Connecting the QFX10000 to External Devices

Connecting a Device to a Network for Out-of-Band Management

168
Connect DC power to each QFX10008 DC power supply, see
2.
DC Power Supply" on page
Each power supply input feed must be connected to a dedicated DC power source
outlet.
QFX10000 DC Power System on page 59
Prevention of Electrostatic Discharge Damage on page 293
Maintaining QFX10000 Power System on page 187
Connecting a Device to a Network for Out-of-Band Management on page 168
Connecting a Device to a Management Console by Using an RJ-45 Connector on page 169
You can monitor and manage these devices by using a dedicated management channel.
Each device has a management port to which you can connect an Ethernet cable with
an RJ-45 connector. Use the management port to connect the device to the management
device.
Ensure that you have an Ethernet cable that has an RJ-45 connector at either end.
Figure 77 on page 168 shows the RJ-45 connector of the Ethernet cable supplied with the
device.

Figure 77: RJ-45 Connector on an Ethernet Cable

To connect a device to a network for out-of-band management (see
Figure 78 on page 169):
Connect one end of the Ethernet cable to the management port (labeled
1.
) on the device.
ETHERNET
Connect the other end of the Ethernet cable to the management device.
2.
200.
Copyright © 2019, Juniper Networks, Inc.
"Installing a QFX10000
MGMT or