Juniper QFX10008 Hardware Manual page 153

Copyright © 2019, Juniper Networks, Inc.
Prepare the site for installation as described in
on page 115.
Ensure the site has adequate clearance for both airflow and hardware maintenance
as described in "QFX10000 Clearance Requirements for Airflow and Hardware
Maintenance" on page 121.
Unpack the switch as described in
In a four-post rack, install the mounting brackets at the desired position (see
the Mounting Hardware for a QFX10000" on page
Review chassis lifting guidelines described in Installation Safety Guidelines and Warnings.
Ensure that you have the following parts and tools available to install the switch:
A mechanical lift rated for 350 lbs. (158.8 kg)
14 mounting screws appropriate for your rack
A Phillips (+) screwdriver, number 2 or number 3, depending on the size of your
rack-mounting screws
CAUTION: If you are installing more than one switch in a rack or cabinet,
install the first switch at the bottom of the rack.
To install the switch using a mechanical lift (see
Ensure that the rack or cabinet is placed in its permanent location and is secured to
1.
the building. Ensure that the installation site allows adequate clearance for both
airflow and maintenance. For details, see
Airflow and Hardware Maintenance" on page
Load the switch onto the lift, making sure it rests securely on the lift platform.
2.
Chapter 3: Initial Installation and Configuration
"QFX10000 Site Preparation Checklist"
"Unpacking the QFX10008" on page
150).
Figure 64 on page
"QFX10000 Clearance Requirements for
121.
142.
"Installing
154):
153