Installing The Qfx10000 Cable Management System; Figure 142: Cable Management System Components - Juniper QFX10008 Hardware Manual

See Also

Installing the QFX10000 Cable Management System

Copyright © 2019, Juniper Networks, Inc.
Screw the line card into the chassis by rotating the handles until the card is fully seated
6.
and the handles are vertical.
Bring the line card online:
7.
user@switch> request chassis fpc slot slot-number online
You can install the optional cable management kit after the card is installed.
Power Requirements for QFX10000 Components on page 124
The QFX10000 cable management system is an optional kit that can be ordered to
organize and protect optical cabling attached to the line cards. After a card is installed,
you can still remove the line card without needing to remove the cable management
system.
Ensure that you have the following parts and tools available to install the QFX10000
cable management system on a line card:
Phillips (+) screwdriver, number 2
To install the cable management system (see
Open the shipping carton for cable management system and check that you have:
1.
Two handle extensions
One cable tray

Figure 142: Cable Management System Components

Use the Phillips screwdriver to loosen and remove the screws on the two line card
2.
handles (see Figure 143 on page
Chapter 4: Maintaining Components
Figure 142 on page
228).
227):
227