Figure 101: Removing An Ac Power Supply From A Qfx10008 - Juniper QFX10008 Hardware Manual

QFX10008 Switch Hardware Guide
190
Turn the adjustment nut of the power cord retainers counterclockwise till you can see
5.
the power cord. Pull the power cord from the slot in the adjustment nuts.
Unscrew the captive screw counterclockwise by using the Phillips (+) screwdriver,
6.
number 1. See Figure 101 on page 190
Rotate the captive screw away from the faceplate of the power supply to release the
7.
latch.
Taking care not to touch the power supply output connections, pins, leads, or solder
8.
connections, place one hand under the power supply to support it. Grasp the power
supply handle with your other hand and pull the power supply completely out of the
chassis.
CAUTION: Do not bump the output connections. If the connection hits a
solid object, it could damage the power supply.
If you are not replacing the power supply, install the cover over the slot by inserting
9.
your thumb and forefinger into the finger holes, squeezing and pulling the cover out
of the slot.

Figure 101: Removing an AC Power Supply from a QFX10008

and Figure 102 on page 191.
Copyright © 2019, Juniper Networks, Inc.