Figure 114: Esd Point On Qfx10008 Chassis Rear; Figure 115: Esd Point On Qfx10016 Chassis Rear - Juniper QFX10008 Hardware Manual

QFX10008 Switch Hardware Guide
202
Attach the electrostatic discharge (ESD) grounding strap to your bare wrist, and
1.
connect the strap to the ESD point on the chassis. There is an ESD point located next
to the protective earthing terminal and below
Figure 114 on page 202) and below
Figure 115 on page 202).

Figure 114: ESD Point on QFX10008 Chassis Rear

1— ESD point

Figure 115: ESD Point on QFX10016 Chassis Rear

1— ESD point
Taking care not to touch power supply components, pins, leads, or solder connections,
2.
remove the power supply from its bag.
Peel back and remove the protective plastic wrap that covers all four sides of the
3.
power supply.
Ensure the power switch is set to the standby (
4.
output voltage; it does not interrupt DC.
on the QFX10008 rear panel (see
PSU 5
on the QFX10016 rear panel (see
PSU_9
O ) position. This switch turns off the
Copyright © 2019, Juniper Networks, Inc.