Figure 62: Unpacking A Line Card - Juniper QFX10008 Hardware Manual

See Also
Copyright © 2019, Juniper Networks, Inc.
the other. All these components are shipped in a cardboard carton, secured with packing
material.
CAUTION: The components are maximally protected inside the shipping
carton. Do not unpack them until you are ready to install the components in
the switch chassis.
Before you unpack a component:
Ensure that you have taken the necessary precautions to prevent electrostatic discharge
(ESD) damage. See "Prevention of Electrostatic Discharge Damage" on page
Ensure that you know how to handle and store the component. (See
Storing QFX10000 Line Cards, RCBs, and SIBs" on page
To unpack an RCB, SIB, or line card, (see
Move the shipping carton to a staging area as close to the installation site as possible.
1.
Position the carton so that the arrows are pointing up.
2.
Open the top flaps on the shipping carton.
3.
Pull out the packing material that holds the component in place.
4.
Remove the component from the electrostatic bag.
5.
Save the shipping carton and packing materials in case you need to move or ship the
6.
RCB, SIB, or line card later.

Figure 62: Unpacking a Line Card

1— Foam packing material
Installing a QFX10000 Line Card on page 224
Chapter 3: Initial Installation and Configuration
173).
Figure 62 on page 145):
2— Paper packaging and electrostatic bag
293.
"Handling and
145