Figure 67: Installing A Qfx10008 In A 4-Post Rack - Juniper QFX10008 Hardware Manual

QFX10008 Switch Hardware Guide
Related
Documentation
158
Carefully slide the switch onto the mounting brackets until the front-mounting brackets
4.
attached to the chassis contact the rack rails. The mounting brackets ensure that the
holes in the front-mounting brackets attached to the chassis align with the holes in
the rack rails. See Figure 67 on page
Install a mounting screw into each of the open front-mounting holes aligned with the
5.
rack, starting from the bottom.
Visually inspect the alignment of the chassis. If the chassis is installed properly in the
6.
rack, all the mounting screws on one side of the rack are aligned with the mounting
screws on the opposite side and the switch is level.
After ensuring that the switch is aligned properly, tighten the screws.
7.

Figure 67: Installing a QFX10008 in a 4-Post Rack

After you install the mounting screws and securely bolt the chassis to the rack, reinstall
the components in the chassis. See:
Installing a QFX10000 Line Card on page 224
Installing a QFX10000 Switch Interface Board on page 215
Installing a QFX10008 Fan Tray on page 182
"Installing a QFX10000 AC Power Supply" on page 191
Power Supply on page 200
Connecting the QFX10000 to Power on page 163
158.
or Installing a QFX10000 DC
Copyright © 2019, Juniper Networks, Inc.