Installing A Qfx10000 Ac Power Supply; Figure 102: Removing An Ac Power Supply From A Qfx10016 - Juniper QFX10008 Hardware Manual

Installing a QFX10000 AC Power Supply

Copyright © 2019, Juniper Networks, Inc.

Figure 102: Removing an AC Power Supply from a QFX10016

Keep latch in open position during removal.
The AC power supply in a QFX10008 and QFX10016 chassis is a hot-insertable and
hot-removable field-replaceable unit (FRU). You can install up to 6 AC power supplies
in a QFX10008 and 10 in a QFX10016 switch chassis. All AC power supplies install in the
rear of the chassis in the slots provided along the left side.
CAUTION: Do not mix AC and DC power supplies in the same chassis.
Before you install an AC power supply in the switch:
Ensure you understand how to prevent ESD damage. See
Discharge Damage" on page
If the AC power source outlets have a power switch, set them to the off (
Ensure that you have the following parts and tools available to install an AC power supply:
Electrostatic discharge (ESD) grounding strap
Phillips (+) screwdriver, number 1
Power cords appropriate for your geographical location. See
Specifications" on page
Power cord retainer clips
To install an AC power supply in a QFX10008 or QFX10016:
293.
54.
Chapter 4: Maintaining Components
"Prevention of Electrostatic
O ) position.
"QFX10000 Power Cord
191