Holding Sibs; Figure 83: Qfx10000 Sib - Juniper QFX10008 Hardware Manual

Holding SIBs

Copyright © 2019, Juniper Networks, Inc.
SIBs are installed vertically and should be held vertically until they are clear of the switch
before rotating them 90 degrees and placing them on an antistatic mat or placing them
in an electrostatic bag for storage. See

Figure 83: QFX10000 SIB

The proper method of holding a SIB is to:
Hold the SIB by the ejectors while you keep the SIB vertical, and slide the SIB about
1.
three-quarters of the way out of the chassis.
Place one hand underneath the SIB to support it, and slide it completely out of the
2.
chassis.
CAUTION: Never hold the SIB by the connector edge. The connectors are
fragile and the SIB will not align and seat properly if the connector is
damaged.
CAUTION: Do not stack SIBs on top of one another or on top of any other
component.
Chapter 4: Maintaining Components
Figure 83 on page 175.
175