Configuring A Qfx10000; Figure 80: Connecting A Device To A Management Console Through A Console; Figure 81: Connecting A Device Directly To A Management Console - Juniper QFX10008 Hardware Manual

QFX10008 Switch Hardware Guide
Related
Documentation

Configuring a QFX10000

170
Connect the other end of the Ethernet cable to the console server (see
2.
Figure 80 on page 170) or management console (see
Figure 80: Connecting a Device to a Management Console Through a Console Server
CON
To Console
port

Figure 81: Connecting a Device Directly to a Management Console

QFX10000 Console and Management Cable Specifications and Pinouts on page 135
You must perform the initial configuration of a QFX10000 modular switch through the
console port using the command-line interface (CLI) or through Zero Touch Provisioning
(ZTP). On QFX10002 fixed-chassis models, in addition to using the CLI, you may also
use ZTP. In order to provision the QFX10002 using ZTP, you must have access to a
Dynamic Host Control Protocol (DHCP) server and a File Transfer Protocol (anonymous
FTP), Hypertext Transfer Protocol (HTTP), or Trivial File Transfer Potocol (TFTP) server
on which the software image and configuration files are stored. For more information
about using ZTP for provisioning the device, see Zero Touch Provisioning.
The following procedure sets up the QFX10000 using the command-line interface (CLI).
Before you begin connecting and configuring the switch, set the following parameter
values on the console server or PC:
Baud Rate—9600
Flow Control—None
Data—8
Parity—None
Stop Bits—1
DCD State—Disregard
Figure 81 on page
Console server
Copyright © 2019, Juniper Networks, Inc.
170).
PC