Port Groups; Channelization Of 40-Gigabit Ethernet Ports; Figure 48: Qfx10000-60S-6Q Port Groups; Table 35: Qfx10000-60S-6Q Port Mapping - Juniper QFX10008 Hardware Manual

Table 35: QFX10000-60S-6Q Port Mapping

4X10-Gigabit
Port Number Ethernet
60
61
62
63
64
65
Copyright © 2019, Juniper Networks, Inc.
Any of the 66 ports through
0
ports are enabled by default, and the default configuration adds the ports to the default
VLAN.

Port Groups

The six combination ports of QSFP28 and QSFP+ can operate either as six independent
40-Gigabit Ethernet ports or as two port groups. The first port group is controlled by
QSFP28 port 60 and administratively bundled with QSFP+ ports
port group is controlled by QSFP28 port
ports and . To enable the port group, insert a 100-Gigabit Ethernet transceiver into
63 65
the QSFP28 port and configure a port for 100-Gbps. Junos OS enables the QSFP28 port
at 100-Gbps speed and disables the two QSFP+ ports bundled in the port group.
Figure 48 on page 87 shows the location of QSFP28 ports and port groups for the
QFX10000-60S-6Q. Table 35 on page 87
ports.

Figure 48: QFX10000-60S-6Q Port Groups

4X10-Gigabit
Channelized 40-Gigabit
Port Group Ethernet

Channelization of 40-Gigabit Ethernet Ports

Channelization from a 40-Gigabit Ethernet port into 4 independent 10-Gigabit Ethernet
ports is supported on the QSFP28 and QSFP+ ports. Channelization to 50-Gbps or
25-Gbps speed is not supported on the 100-Gigabit Ethernet QSFP28 port. All ports in
can be configured as either uplink or access ports. The
65
and administratively bundled with QSFP+
64
shows the available combinations for the
100-Gigabit
Ethernet
–
–
–
–
Chapter 1: Overview
61 and 62 . The second
100-Gigabit Ethernet Disables
61, 62
–
–
–
63, 65
–
87