Qfx10000 Management Port Leds; Figure 33: Rcb Status Panel Leds; Table 21: Control Board Status Leds - Juniper QFX10008 Hardware Manual

Table 21: Control Board Status LEDs

LED
PWR
STS
MST
Copyright © 2019, Juniper Networks, Inc.

Figure 33: RCB Status Panel LEDs

1— PWR
Power ( ) LED
2— STS
Status ( ) LED
Table 21 on page 69 describes the LEDs on the RCB status panel.
Color State
Green On steadily
Yellow Blinking
Dark Unlit
Green On steadily
Green Blinking
Yellow On steadily
Yellow Blinking
Dark Unlit
Green On steadily
Dark Unlit

QFX10000 Management Port LEDs

There are two management ports on the RCB of a QFX10008 and QFX10016 that have
LEDs that indicate link status and link activity. These two ports, located on the RCB panel
between the clocking connections and the USB port, are both labeled
management port is an SFP cage that can accommodate up to 1G copper or fiber
connections (see Figure 34 on page
status and activity. The fiber (SFP) port has a combination link and activity LED.
3— MST
Master ( ) LED
4— Offline button
Description
The RCB is receiving adequate power.
The RCB has detected an error.
The RCB is not powered up.
The RCB is online and functioning correctly.
The beacon feature is enabled.
The RCB is booting.
The RCB has detected an error.
The power supply is switched off.
The RCB is the master.
The RCB is the backup.
70). The copper (RJ-45) port has separate LEDs for
Chapter 1: Overview
MGMT . The left
69