QFX10008 Switch Hardware Guide
198
Attach the electrostatic discharge (ESD) grounding strap to your bare wrist, and
1.
connect the strap to the ESD point on the chassis. There is an ESD point located next
to the protective earthing terminal and below
Figure 110 on page
198) and below
Figure 110: ESD Point on Chassis Rear
1— ESD point
Figure 111: ESD Point on QFX10016 Chassis Rear
1— ESD point
Make sure that the voltage across the DC power source cables leads is 0 V and that
2.
there is no chance that the cables might become active during the removal process.
Ensure the black power supply output switch, to the right of the captive screw, is set
3.
to the standby position.
Unscrew the captive screw counterclockwise by using the Phillips (+) screwdriver,
4.
number 1.
on the QFX10008 rear panel (see
PSU 5
on the QFX10016 (see
PSU_9
Copyright © 2019, Juniper Networks, Inc.
Figure 111 on page
198).