Figure 143: Removing The Handle Screws; Figure 144: Adding Handle Extensions - Juniper QFX10008 Hardware Manual

QFX10008 Switch Hardware Guide
228

Figure 143: Removing the Handle Screws

Replace the blue cap on the line card handle with the two handle extensions (see
3.
Figure 144 on page 228).

Figure 144: Adding Handle Extensions

Tighten the screws into the handle extensions.
4.
Snap open the blue clips on the ends of the cable tray with your hands.
5.
Place the cable tray across the front of the line card so that the two ends of the cable
6.
tray are under the handle extensions.
Snap to close the blue clips of the cable tray around the handle extensions (see
7.
Figure 145 on page 229).
Copyright © 2019, Juniper Networks, Inc.