Figure 150: Esd Point On Qfx10008 Chassis Front; Figure 151: Esd Point On Qfx10016 Chassis Front; Figure 152: Removing The Sata Ssd Cover - Juniper QFX10008 Hardware Manual

Copyright © 2019, Juniper Networks, Inc.
To install either size of SATA SSD in a QFX10000:
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
1.
point on the front of the chassis. There is an ESD point located above the status LED
panel on the right side (see

Figure 150: ESD Point on QFX10008 Chassis Front

Figure 151: ESD Point on QFX10016 Chassis Front

1— ESD point
Loosen the two captive screws to remove the cover on the RCB by using the
2.
Phillips (+) screwdriver, number 1 (see

Figure 152: Removing the SATA SSD Cover

Remove the SATA SSD from the electrostatic bag, taking care not to touch the
3.
connectors.
Slide the SATA SSD into the open slot until the pins engage and the faceplate is flush
4.
with the front panel of the Control Board (see
Figure 150 on page 233 and
1
Figure 152 on page
Figure 153 on page
Chapter 4: Maintaining Components
Figure 151 on page 233).
233).
234).
233