Connecting A Fiber-Optic Cable; Maintaining Fiber-Optic Cables; Figure 156: Connecting A Fiber-Optic Cable To An Optical Transceiver Installed - Juniper QFX10008 Hardware Manual

QFX10008 Switch Hardware Guide

Connecting a Fiber-Optic Cable

Maintaining Fiber-Optic Cables

240
Before you begin to connect a fiber-optic cable to an optical transceiver installed in a
device, ensure that you have taken the necessary precautions for safe handling of lasers
(see Laser and LED Safety Guidelines and Warnings).
To connect a fiber-optic cable to an optical transceiver installed in a device:
WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to transceivers emit laser light that can damage your eyes.
If the fiber-optic cable connector is covered with a rubber safety cap, remove the cap.
1.
Save the cap.
Remove the rubber safety cap from the optical transceiver. Save the cap.
2.
Insert the cable connector into the optical transceiver (see
3.
Figure 156: Connecting a Fiber-Optic Cable to an Optical Transceiver Installed in a Device
Secure the cables so that they do not support their own weight. Place excess cable
4.
out of the way in a neatly coiled loop. Placing fasteners on a loop helps cables maintain
their shape.
CAUTION: Do not bend fiber-optic cables beyond their minimum bend
radius. An arc smaller than a few inches in diameter can damage the cables
and cause problems that are difficult to diagnose.
Do not let fiber-optic cables hang free from the connector. Do not allow
fastened loops of cables to dangle, which stresses the cables at the
fastening point.
Fiber-optic cables connect to optical transceivers that are installed in Juniper Networks
devices.
Figure 156 on page
Copyright © 2019, Juniper Networks, Inc.
240).